ARP Stainless Steel bolt kits

Polished Stainless 6-point bolt kits are available for the following Z32 applications (the number in parenthesis is the number of bolts and/or nuts in each kit, one washer per bolt or nut is included). Kits marked with an asterisk (*) are the most visible on the engine.

*Upper plenum (8) - $46.50

 

*Throttle bodies and linkage (11) - $58.34

 

*CAS (3) - $8.35

 

*Coil packs (12) - $34.37

 

*Plenum crossover/Balance tube (replaces studs with bolts (5)) - $16.24

 

*Under hood body panels (fender (6), center panel and radiator brackets(6)) - $36.61

 

CAS bracket (3) - $16.99

 

Exhaust valve covers (16) - $46.34

 

Intake valve covers, eliminates stock rubber crush washers (16) - $50.69

 

Idle air valves (6) - $23.84

 

Spark plug covers (8) - $44.42

 

Lower plenum (uses stock studs and thick washers (6 bolts, 4 12-point nuts)) - $63.68

 

Oil pump (6) - $25.06

 

Stock water pump (5) (retains stock bolt for timing belt cover) - $25.28

 

TT Oil pan (17) - $48.69

 

TT oil filter tree (4) - $16.35

 

Thermostat housing (replaces studs with bolts (8)) - $35.01

 

Stock motor mounts to block (8) - $47.10

 

Timing belt tensioner/idlers (uses stock 10mm idler studs (7 bolts, 2 12-point nuts)) - $42.10

 

Alternator bracket (5) - $25.73

 

Bellhousing to block (6) - $38.75

 

'90-'93 TT Power steering pump and bracket (9) - $38.85

 

NA and '94+TT Power steering pump and bracket (9) - $43.70

 

AC compressor and bracket (7) - $35.07

 

Heater pipes or VTC solenoids (4) - $11.46

 

Front water outlets from heads or rear main seal retainer (4) - $11.58

 

 
     

2008-2017 Brett Dempsey Engineering

Brett Dempsey || Webmaster

This Website Optimized for 1024x768 and Higher Resolutions